Soft Starter Help Info and Parameter Updates
GW and GS Series Help Info (Error Log and Stats)
When the Soft Starter is powered on and showing a READY STATE on the screen, press the YES button. The screen will then display information as listed below – scroll to the relevant option using the Up and Down arrow buttons on the Keypad:
- VOLTAGE: Shows the AC Input Power Supply Voltage
- SPEC: Shows the Amp and Voltage rating of the Soft Starter
- H1: Shows the latest Error (Error Code and Description)
- H2 ~ H9: Shows list of previous Errors as per H1 above.
- VERSION NUMBER: Shows the Control Board Software Version Number
- NUMBER OF STARTS: Shows the number of times the Soft Starter were running.
- LAST TIME: Ignore (in future will show the total running time of the previous/last run).
GW and GS Series Parameter Modifications
When the Soft Starter is powered on and showing a READY STATE on the screen, press the SET button. The screen will then display a specific parameter and its value. Scroll to the relevant parameter option using the Up and Down arrow buttons on the Keypad and press the SET button key again if the parameter needs to be modified (the colon after the parameter code will flicker when in edit mode). When in edit mode the Up and Down arrow buttons on the Keypad can be used to adjust the parameter to the desired value. When done adjusting the parameter value, press the YES button on the keypad (the Keypad will show GOOD – Program for a moment and then a READY STATE will be shown on the screen).
